Overview of potential for energy savings
Pump audit is a diagnostic tool developed by Grundfos to identify excessive energy consumption in any kind of pumping system. Our experience with Pump audits shows that 30-50% of the energy consumed by pumps could be saved which translates into significant potential savings for your installation, and a little extra relief for the environment.
A Pump audit is performed by Grundfos specialists based on measurements. It focuses on the amount of material the pump is handling and flow variations during a relatively short and well-defined period. The Grundfos specialist sets up various measuring equipment to measure and record the following:
- Countable values, e.g. flow and energy consumption
- Analogue values, e.g. pressure, temperature, water levels
- Incident rates, e.g. pump start/stop, valve open/close
The audit assesses the overall efficiency of your pumps and proposes changes to be made to improve efficiency. The proposals are supported by calculations of the savings to be made, the reduction in CO2 emissions, and the payback time on any investment.
- Considerable savings on running costs
- Significant reductions to installation carbon footprint
APPOINTMENT WITH CONSULTANT
We prequalify your site through a discussion of relevant site information or an Energy Check.
We inspect your premises and draw up a list of performance data and installed pumps, pinpointing focus areas.
The Pump Audit is carried out by logging data, resulting in a load profile for the pump(s) audited
You receive a hardcover report with full details of the audit results and recommendations.
- You may select the right pump solution for your system.
- Optimum performance
- Energy and cost savings
We follow up on the service performed to ensure optimal service delivery and satisfactory Grundfos pump performance.
BM 4", 6", 8" high pressure booster modules
Grundfos high-pressure booster modules are used for boosting, liquid transfer and circulation in systems under high...
CR vertical multistage centrifugal inline pumps
The basic CR pump range, which can be applied in almost any industrial solution, is already in itself the broadest...
GT diaphragm and bladder pressure tanks
The GT tanks are available in sizes from 8 to 3,000 litres, suitable for vertical installation. The GT-H tanks have...
HS horizontal split case pumps
The Grundfos HS horizontal split case pump is a single-stage, non-self-priming, between bearing, centrifugal volute...
Hydro MPC - pressure boosting building service applications
The Grundfos Hydro MPC booster systems are made to the very highest standards. Thanks to the CU 351 controller,...
Hydro Multi-E - pressure boosting building service applications
Hydro Multi-E is an innovative pressure booster system, specially designed for building service applications. Hydro...
NB, NBG, NBE, NBGE end-suction close-coupled pumps
Grundfos end-suction pumps are used in water supply, industrial pressure boosting, industrial liquid transfer, HVAC...
NK, NKG, NKE, NKGE end-suction long-coupled pumps
Grundfos NK/NKG pumps are used in water supply, industrial pressure boosting, industrial liquid transfer, HVAC...
SP submersible groundwater pump
Grundfos SP submersible pumps are renowned for their high efficiency and reliability throughout the range. Made...
Select country to select your local service company